Updating your K-TAG clone from version 2.25 to 2.70 can unlock significantly more car models and protocols, but it requires a very specific sequence to avoid bricking the device.
: These must be installed for the software to run correctly.
While the 2.70 software is often used to of the device, many technicians still use version 2.25 as the primary "working" interface for the actual reading and writing of ECUs. Prerequisites for the Update Before starting, ensure you have the following ready: update ktag clone from 225 to 270 new
Once the device is confirmed working on the older software, . Disconnect the K-TAG tool from the USB port.
Open version 2.25 and check the protocol list. You should now see that previously "greyed out" or missing protocols are now active and selectable. Updating your K-TAG clone from version 2
completely before you begin.
: Adds compatibility for modern Bosch EDC17 and MED17 units, including improved checksum correction for certain microprocessors. Prerequisites for the Update Before starting, ensure you
Connect your K-TAG device via USB and confirm it is detected by the computer.
Open the folder and run the driver installer provided within that specific folder. Reconnect the K-TAG tool and open the 2.70 software.
: Only enable this at specific steps indicated below. Caution : Connecting a clone device to the internet at the wrong time can permanently block the NXP chip. Step-by-Step Update Guide 1. Initial Software Installation