Ts1162 Installation Manual ^new^ «500+ VERIFIED»

The Challenger system identifies each keypad by its unique RAS address, which must be set manually before the unit is powered up.

If the TS1162 is the last device on a long RS-485 cable run, set the termination DIP switch (typically Switch 8) to the 'ON' position to prevent data signal reflections. 4. System Integration

For environments where the keypad face may become worn, a replacement TS1162-LABEL (membrane) is available to restore the unit's appearance and button legibility. ts1162 installation manual

Once physically installed and addressed, the keypad must be enabled within the Challenger system programming: Access the (Default code: 4346 ). Navigate to the RAS Configuration menu. Enable the specific RAS address you assigned to the TS1162.

Pull the bottom of the body away from the base and lift it off the top tabs. The Challenger system identifies each keypad by its

12V DC power from the Challenger LAN or an external power supply.

If the device is more than 100 meters from the main panel, it is recommended to use an external 12V power supply while maintaining a common negative (–) reference with the LAN. 3. Configuration (Addressing & Termination) System Integration For environments where the keypad face

Ensure the mounting surface allows the rear tamper lever to be fully depressed when the unit is secured. Enclosure Removal: Undo the retaining screws at the bottom of the keypad.

Test the keypad by entering a valid user code to arm/disarm the assigned areas.