Press and hold the (usually hidden under the dashboard) until the siren chirps.
Before diving into the technical settings, it’s important to understand what this unit offers:
Allows you to trigger the siren to locate your car in a crowded lot. manual alarme wr 800pdf full
Check the 12V battery inside the fob (usually a CR2032 or A27). If the battery is fine, you may need to re-pair the remote using the steps above.
This is often caused by the ultrasonic sensors being set too high. Use the sensitivity adjustment screw on the side of the main module to turn it down. Press and hold the (usually hidden under the
Press the on the new remote. The siren will chirp to confirm. Turn the Ignition OFF to exit programming mode. Troubleshooting Common Issues
According to the , the wiring harness generally follows a standard color code: Red: Constant +12V Battery. Black: Chassis Ground. Yellow: Ignition Switch (+12V when the key is turned). Green: Door Switch (Negative trigger). Violet: Siren Output. Orange: Parking Lights. Programming New Remotes If the battery is fine, you may need
Understanding the WR 800 Alarm System: A Comprehensive Guide