Front Panel Audio (F_AUDIO)Supports High Definition Audio (HD) or AC'97 standards. By default, it is configured for HD Audio. Clearing CMOS (Password/BIOS Reset)
Maximum Capacity: 8GB (2 x 4GB modules)Speed: DDR3 800 / 1066 MHzArchitecture: Dual-channel support
1 x VGA port (Integrated Intel GMA X4500 graphics)4 x USB 2.0 ports1 x RJ-45 Ethernet port (Realtek RTL8103EL)3 x Audio jacks (Line-in, Line-out, Microphone)Legacy PS/2 ports for keyboard and mouse Installation Tips and Common Issues h-ig41-uatx rev 1.1 manual
This motherboard uses DDR3 memory, which was a transitionary feature for the G41 chipset.
The H-IG41-uATX Rev 1.1 supports a variety of 65nm and 45nm Intel processors. Note that the maximum Thermal Design Power (TDP) for this board is typically 65W or 95W depending on the specific BIOS version. The H-IG41-uATX Rev 1
USB Headers (F_USB1 / F_USB2)These allow for front-case USB 2.0 ports. Each header supports two USB ports. Ensure the red wire (VCC) aligns with Pin 1.
If you need to reset the BIOS settings or clear a forgotten password, locate the jumper labeled CLR_CMOS or JBAT1. Turn off the PC and unplug the power cable. Each header supports two USB ports
Move the jumper cap from pins 1-2 (Normal) to pins 2-3 (Clear). Wait 15 seconds. Return the jumper to pins 1-2. Plug in and restart. Rear I/O Port Layout The back panel of the H-IG41-uATX typically includes:
Intel Core 2 Quad (up to Q9xxx series)Intel Core 2 Duo (up to E8xxx series)Intel Pentium Dual-CoreIntel Celeron 400 series Memory Configuration