Gt911 - Register Map

This block is often sent as a complete "config array" during initialization. 3. Register Map

Defines screen resolution, touch thresholds, and sensor layout. Coordinate/Status Registers

This register is used to trigger specific device states. Common commands include: 0x00 : Read coordinate status. 0x05 : Enter to save power. 0x06/0x07 : Enter/Exit Charge mode for enhanced sensitivity. Configuration Registers (0x8047+) gt911 register map

The register map is divided into three primary functional areas: Address Range Access Type Description Command Register Write Only Sends high-level commands like Sleep or Calibration. 0x8047 – 0x8100 Configuration Registers Read/Write

The GT911 operates as an I2C slave. Before accessing the register map, you must establish the correct slave address. This block is often sent as a complete

Understanding this map is essential for developers writing custom drivers or troubleshooting touch response issues in embedded systems.

The GT911 uses 16-bit register addresses. It supports auto-incrementing , allowing you to read or write a continuous block of data in a single I2C transaction. 2. Core Register Map Structure Coordinate/Status Registers This register is used to trigger

Depending on the state of the INT and RESET pins during power-on, the device uses either 0xBA/0xBB or 0x28/0x29 (8-bit write/read format).