If you are transporting your bike on a trailer or train, you can disable the motion sensor while keeping the alarm armed: Arm the alarm by pressing . Press Button 1 again within the activation phase.
If you arm the alarm more than one minute after turning off the ignition, you must hold Button 1 for longer than one second. If the bike is left deactivated for over an hour, the system may shut down to save battery; in this case, cycle the ignition to wake it up. Deactivating the Motion Sensor
Hi all, As I mentioned in one of my previous posts I was going to change the two small batteries in my BMW alarm box (Gemel TXSHS) Gemel TXSHS alarm operating advice needed - UKGSer
Insert the new battery, ensuring it does not touch other electrical components. The LED should light up once the battery is in place.
Press both Button 1 and Button 2 simultaneously. Hold them for approximately 10 seconds until the LED on the remote stops flashing.
Gemel Txshs User Manual Link [TOP]
If you are transporting your bike on a trailer or train, you can disable the motion sensor while keeping the alarm armed: Arm the alarm by pressing . Press Button 1 again within the activation phase.
If you arm the alarm more than one minute after turning off the ignition, you must hold Button 1 for longer than one second. If the bike is left deactivated for over an hour, the system may shut down to save battery; in this case, cycle the ignition to wake it up. Deactivating the Motion Sensor Gemel Txshs User Manual
Hi all, As I mentioned in one of my previous posts I was going to change the two small batteries in my BMW alarm box (Gemel TXSHS) Gemel TXSHS alarm operating advice needed - UKGSer If you are transporting your bike on a
Insert the new battery, ensuring it does not touch other electrical components. The LED should light up once the battery is in place. If the bike is left deactivated for over
Press both Button 1 and Button 2 simultaneously. Hold them for approximately 10 seconds until the LED on the remote stops flashing.