Dp Dual Trac 20 Assembly Instructions Full ((hot)) May 2026

Insert the center selector rod through the plates and attach the cable end to the top of the rod.

The DP Dual Trac 20 uses a dual-cable system. Success here is all about following the path:

Insert the weight guide rods into the base. Slide your weight plates on one by one. dp dual trac 20 assembly instructions full

Attach the front and rear stabilizer bars to the main central base frame. Use the long carriage bolts provided.

Run the handles through a full range of motion without any weight plates pinned to ensure the cables are tracking correctly. Insert the center selector rod through the plates

Lay out all bolts and nuts by size before starting. This prevents using the wrong hardware in early steps. Step 1: The Main Frame and Base Start by assembling the "skeleton" of the machine.

Before you begin, clear a 6' x 8' space for the machine and grab the following tools: Two adjustable wrenches (or a socket set) A Phillips head screwdriver A rubber mallet (optional, for seating end caps) Slide your weight plates on one by one

Lift the top horizontal frame piece onto the vertical upright. Secure it with the heavy-duty bolts and washers.

Attach the fixed pulley brackets to the top frame and the base. Note the orientation: the "open" side of the bracket should face where the cable will enter. Step 4: Cable Routing (The Critical Phase)