Manual !full!: Bst900w

Adjust your V and A, then long-press SET . Choose a location (e.g., M0) and press OK .

Use thick-gauge copper wire to handle up to 15A of current to prevent overheating or voltage drops. 6. Troubleshooting

To access these, hold the button while powering on the device. Toggle between n=0 (Disabled) and n=1 (Enabled) using the arrows. 5. Wiring and Safety Precautions bst900w manual

Your input power supply may not be able to provide enough current. Check the "Input Current" limits.

The BST900W features a four-digit LED display and four control buttons: Adjust your V and A, then long-press SET

This is a Boost converter. The input voltage must be lower than the output voltage.

Press the SET button again until the "A" indicator lights up. Adjust the maximum output current using the arrows. the onboard fan should be active.

Ensure your input voltage is at least 2V lower than your target output.

At high loads (above 500W or 10A), the onboard fan should be active. Ensure there is plenty of airflow around the heatsinks.